Arduino Compatible Stepper Motor Controller Module – Back-EMF & Over-Temp Protection

You've got two stepper motors begging to spin and a breadboard full of loose wires. This module keeps them both under control without you babysitting the voltage. Back-EMF and over-temperature protection are built in, so a stalled motor won't cook your board. The on-board 5V regulator means you can run your Arduino off the same supply — one less jumper to wire. Screw terminals keep connections clean, no soldering required. LEDs tell you at a glance whether power and output are live. Needs six digital pins and bolts down with four mounting holes. One thing to note: if you're driving above 12V, feed an external 5V logic supply. Don't skip that. Add to cart and it's on your bench this week

• Back-EMF and over-temperature protection for reliable two-motor driving
• On-board 5V regulator powers your Arduino or project board directly
• Screw terminals — no soldering, clean connections every time
• Status LEDs show power and output state at a glance
• Requires six digital pins; four mounting holes for a secure fit
• Use an external 5V logic supply when driving above 12V