Jaycar Outboard Motor Slop Well Drain – Fiberglass Transom Fit

Water's sitting under your outboard and you're wiping it out with a sponge every time you land. This slop well drain fixes that for good. It fits through the transom behind and under your motor, then overboard. Made for fiberglass boats. Bore a 25mm hole from the very bottom of the slop well, angled slightly downward, through to the outside. The unit is about 55mm long; the outer ring seal takes up 7–8mm, so your hull gap needs to be 45mm or less. Seal the outer ring and inner sleeve with Silastic or a similar marine sealant. Most boats take two – one each side of the well. Sorted

• Fits through the transom behind and under the outboard motor
• Designed for fiberglass boat hulls
• Requires a 25mm bore from the slop well bottom, angled slightly downward
• Approx. 55mm long; hull gap must be 45mm or less (outer ring seal uses 7–8mm)
• Seal outer ring and inner sleeve with Silastic or similar marine sealant
• Typically fitted in pairs – one each side of the slop well