Ubiquiti UniFi Long-Range Ethernet Repeater – Up to 1 km PoE Extension

Your camera's 400 metres out. Your access point's on the other side of the yard. Standard Cat6 tops out at 100 m and you're stuck running a second switch or pulling new cable through the roof cavity.

This repeater plugs in, takes PoE/PoE+ on one port, and passes it straight through the other. Chain them in 100 m increments and you've got a clean run up to 1 km. No extra switch, no signal loss, no 'it's probably fine' guesswork.

Handles -40 to 80 °C, so it lives outside on a pole or inside a rough shed without complaint. 10 kA+ surge protection means a storm doesn't take your AP offline.

One note: it draws power on pins 1, 2+ and 3, 6−. A UniFi PoE+ switch handles that natively. If you're running third-party gear, check the pinout before you plug in.

Add to cart when you're ready to kill that long cable run

• Extends Ethernet runs up to 1 km in 100 m chainable increments
• 2× GbE RJ45 ports – PoE/PoE+ input and passthrough PoE output
• Operates from -40 °C to 80 °C, suitable for outdoor deployment
• 10 kA+ surge protection for storm-prone sites
• Chain multiple units together to reach distant cameras or access points